ccna 4 final 2012

Our Sponsors

ccna 4 final 2012 (95%)

EWAN Final Exam – CCNA Exploration: Accessing the WAN (Version 4.0)
1

Refer to the exhibit. Communication between two peers has failed. Based on the output that is shown, what is the most likely cause?

ccna 4 final 2012

ccna 4 final 2012

interface reset

unplugged cable

improper LMI type

PPP negotiation failure

2

Refer to the exhibit. A network administrator is tasked with completing the Frame Relay topology that interconnects two remote sites. How should the point-to-point subinterfaces be configured on HQ to complete the topology?

ccna 4 final 2012

ccna 4 final 2012

frame-relay interface-dlci 103 on Serial 0/0/0.1
frame-relay interface-dlci 203 on Serial 0/0/0.2

frame-relay interface-dlci 301 on Serial 0/0/0.1
frame-relay interface-dlci 302 on Serial 0/0/0.2

frame-relay map ip 192.168.1.1 103 broadcast on Serial 0/0/0.1
frame-relay map ip 192.168.2.2 203 broadcast on Serial 0/0/0.2

frame-relay map ip 192.168.1.1 301 broadcast on Serial 0/0/0.1
frame-relay map ip 192.168.2.2 302 broadcast on Serial 0/0/0.2 [Read more...]

CCNA 4 Final Exam 2011 Answers Updated

CCNA 4 Final Exam 2011 Answers Updated

1
Refer to the exhibit. Branch A has a non-Cisco router that is using IETF encapsulation and Branch B has a Cisco router. After the commands that are shown are entered, R1 and R2 fail to establish the PVC. The R2 LMI is Cisco, and the R1 LMI is ANSI. The LMI is successfully established at both locations. Why is the PVC failing?

The PVC to R1 must be point-to-point.
LMI types must match on each end of a PVC.
The frame relay PVCs cannot be established between Cisco and non-Cisco routers.
The IETF parameter is missing from the frame-relay map ip 10.10.10.1 201 command. [Read more...]

ccna 4 final 2011 97%

ccna 4 final 2011 97%

Download now [Read more...]

CCNA 4 Final Exam V4.0 Answers

CCNA 4 Final Exam V4.0 Answers Updated 2011 100%

1. What functionality do access control lists provide in the implementation of dynamic NAT on a Cisco router?

define which addresses can be translated

define which addresses are assigned to a NAT pool

define which addresses are allowed out the router

define which addresses can be accessed from the inside network

2. Which three guidelines would help contribute to creating a strong password policy? (Choose three.)

Once a good password is created, do not change it.

Deliberately misspell words when creating passwords.

Create passwords that are at least 8 characters in length.

Use combinations of upper case, lower case, and special characters.

Write passwords in locations that can be easily retrieved to avoid being locked out.

Use long words found in the dictionary to make passwords that are easy to remember. [Read more...]

CCNA 4 Chapter 8 V4.0 Answers

1. What combination of IP address and wildcard mask should be used to specify only the last 8 addresses in the subnet 192.168.3.32/28?
192.168.3.32 0.0.0.7
192.168.3.32 0.0.0.15
192.168.3.40 0.0.0.7
192.168.3.40 0.0.0.15

2. Excessive broadcasts are generally a symptom of a problem at which layer?
physical
data link
network
transport [Read more...]

CCNA 4 Chapter 7 V4.0 Answers

CCNA 4 Chapter 7 V4.0 Answers 2011 updated

Contact: ccnafinal.net@gmail.com

1.

ccna 4 chapter 7

ccna 4 chapter 7

Refer to the exhibit. Traffic exiting R1 is failing translation. What part of the configuration is most likely incorrect?
ip nat pool statement
access-list statement
ip nat inside is on the wrong interface
interface s0/0/2 should be a private IP address [Read more...]

CCNA 4 Chapter 6 V4.0 Answers

1. Which two protocols can be used to encapsulate traffic that is traversing a VPN tunnel? (Choose two.)
ATM
CHAP
IPsec
IPX
MPLS
PPTP [Read more...]

CCNA 4 Chapter 5 V4.0 Answers

1. The following commands were entered on a router:
Router(config)# access-list 2 deny 172.16.5.24
Router(config)# access-list 2 permit any
The ACL is correctly applied to an interface. What can be concluded about this set of commands?
The wildcard mask 0.0.0.0 is assumed.
The access list statements are misconfigured.
All nodes on the 172.16.0.0 network will be denied access to other networks.
No traffic will be allowed to access any nodes or services on the 172.16.0.0 network.


2. Interface s0/0/0 already has an IP ACL applied inbound. What happens when the network administrator attempts to apply a second inbound IP ACL?
The second ACL is applied to the interface, replacing the first.
Both ACLs are applied to the interface.
The network administrator receives an error.
Only the first ACL remains applied to the interface.
3. Which two statements are correct about extended ACLs? (Choose two)
Extended ACLs use a number range from 1-99.
Extended ACLs end with an implicit permit statement.
Extended ACLs evaluate the source and destination addresses.
Port numbers can be used to add greater definition to an ACL.
Multiple ACLs can be placed on the same interface as long as they are in the same direction. [Read more...]

CCNA 4 Chapter 4 V4.0 Answers

1. Which two statements are true regarding network security? (Choose two.)
Securing a network against internal threats is a lower priority because company employees represent a low security risk.
Both experienced hackers who are capable of writing their own exploit code and inexperienced individuals who download exploits from the Internet pose a serious threat to network security.
Assuming a company locates its web server outside the firewall and has adequate backups of the web server, no further security measures are needed to protect the web server because no harm can come from it being hacked.
Established network operating systems like UNIX and network protocols like TCP/IP can be used with their default settings because they have no inherent security weaknesses.
Protecting network devices from physical damage caused by water or electricity is a necessary part of the security policy.


2. Which two statements are true about network attacks? (Choose two.)
Strong network passwords mitigate most DoS attacks.
Worms require human interaction to spread, viruses do not.
Reconnaissance attacks are always electronic in nature, such as ping sweeps or port scans.

A brute-force attack searches to try every possible password from a combination of characters.
Devices in the DMZ should not be fully trusted by internal devices, and communication between the DMZ and internal devices should be authenticated to prevent attacks such as port redirection. [Read more...]

CCNA 4 Chapter 3 V4.0 Answers

1. Which three actions might a Frame Relay switch perform when it detects an excessive build-up of frames in its queue? (Choose three.)
puts a hold on accepting frames in excess of the CIR
drops frames from the queue that have the DE bit set
reduces the number of frames it sends over the link
re-negotiates flow control with the connected device
sets the FECN bit on all frames it receives on the congested link
sets the BECN bit on all frames it places on the congested link

2. Which best describes the benefit of using Frame Relay as opposed to a leased line or ISDN service?
Customers can define their virtual circuit needs in far greater combinations, with increments as small as 64 kbps.
Customers pay for an end-to-end connection that includes the local loop and the network link.
Customers only pay for the local loop and the bandwidth they purchase from the network provider.
Connecting new sites requires new lower cost circuit installations when compared to ISDN dialup costs or adding additional hardware for leased service.


3.

[Read more...]